Want to know more about our roof edge protection systems? Or do you have a specific question about transport? You can find it all on our FAQ page. Is your question not listed? Please contact your dealer.
This should always be assessed on site. A zinc box or mast gutter with sufficient gutter brackets (every 60 cm and fixed in healthy wood) is usually a strong gutter. Gutters made of plastic or synthetic material are definitely not. The rule of thumb that you can use: you should be able to stand in the gutter. If the gutter is questionable or bad, the system can still be installed, provided that the RSS base plate is also used.
This is only possible when using the RSS base plate.
Yes, to apply the system to a flat roof, there must be a raised edge of at least 6 cm behind which the upright can hook. In addition, the round plate of the upright must be able to rest against a hard material, such as a wall or facade.
National legislation applies here. Usually you are required to take safety measures from a standing height of 2.5 meters. Think of a harness or other individual safety measures. The system can also be built up with a cherry picker or lift.
The system can be used as long as the maximum wind force is observed, see the manual. To make the system more stable, an accessory can be used: the RSS wind protection.
This can be done at one of our rental dealers. To do this, go to Dealers and navigate to rental.
To store and easily transport the RSS Sloping Roof system.
For RSS Pitched Roof, 3 meter and 2 meter fences are immediately available.
Yes, this system is foldable and therefore easy to store and transport.
Yes, once the system is in place it can be lifted to work underneath. This saves a lot of time and energy in setting up and taking down. For your own safety, make sure you are personally attached.
Only 1 concrete block is needed per stanchion.
Yes, the fences are the same and therefore interchangeable.
Yes, the concrete blocks are the same and can also be used with other RSS-Roof systems.
No, but the uprights are easy to fold and therefore easy to transport. You can choose to use the Compact frame for the concrete blocks and fences.
Yes, the fences of the RSS sloping roof system can be used for this system.
This is possible at one of our rental dealers.To do this, go to the 'dealers' menu item and navigate to rental.
Because it is an extra-narrow flat roof system with a compact stanchion, it provides additional workspace for tasks or, for example, installing an extra row of solar panels.
The Compact stanchion is only 60 cm wide, making it significantly narrower than other flat roof systems.This leaves additional workspace available on the roof.
To store and transport the system (up to 40 meters) from the RSS Flat Roof Compact system.
Yes, the fences of the RSS Pitched Roof system can be used for this system.
When the height of the roof edge is less than 150 mm.
Yes, all RSS concrete blocks have recesses in the corners, making them suitable for any system. applicable and are also easy to stack for transport. Ask the nearest dealer to the possibilities.
A transport frame can hold 40 meters, including all accessories, concrete blocks, stanchions, and fences.
The side boards for this system are equipped with a long aluminum hook that can be easily attached to the fence.
This is possible at one of our rental dealers.To do this, go to the 'dealers' menu item and navigate to rental.
The Roof Shelter can be used as a flat roof system as well as a facade system. One system for multiple roof types can be a smart investment. You only need a few additional components to use the system for both roof types.
The concrete blocks do not need to be used when using the RSS Roof Shelter for sloping roofs.
Yes, the concrete blocks are stackable due to the different recesses in each corner.
Yes, the concrete blocks can be used universally with all RSS-Roof systems that use concrete blocks.
Yes, there is a transport frame available. This can hold a total of 24 meters. These transport frames are easily stackable and optimized for transport and storage.
There are special recesses in the side plank that can be placed on the roof beam. An elastic band goes around this and then the concrete blocks have to be placed against this.
This is possible at one of our rental dealers.To do this, go to the 'dealers' menu item and navigate to rental.
This system is 69 cm wide in total. Relatively narrow for a collective flat roof system. This leaves sufficient working surface on the roof.
The Roof Shelter can be used as a flat roof system as well as a facade system. One system for multiple roof types can be a smart investment. You only need a few additional components to use the system for both roof types.
The concrete blocks are placed with the short side towards the fence. In addition, you must start with 1 concrete block on a red roof beam and finish with 2 concrete blocks on top of each other. See the manual for further explanation.
Yes, the concrete blocks are stackable due to the different recesses in each corner.
Yes, the concrete blocks can be used universally with all RSS-Roof systems that use concrete blocks.
Yes, there is a transport frame available. This can hold a total of 24 meters. These transport frames are easily stackable and optimized for transport and storage.
If the height of the roof edge is less than 150 mm.
There are special recesses in the side plank that can be placed on the roof beam. An elastic band goes around this and then the concrete blocks have to be placed against this.
This is possible at one of our rental dealers.To do this, go to the 'dealers' menu item and navigate to rental.
This is a great responsibility that we share together. Clients, employers, but also employees must do everything they can to be well prepared and to be able to work safely. Together with you, we are on a mission to let everyone work safely. And that starts today!
Employees may only work at height from a safe and ergonomically responsible scaffolding, platform, work platform or work floor. If this is not feasible, a suitable work tool must be chosen to make the work as safe as possible.
Our products are periodically inspected by the inspection body ABOMA. As a result, our pitched and flat roof systems both have EN13374 + A1 2019 certification. Our flat roof edge protection meets the requirements for a roof pitch of class A (up to 10°). Our sloping roof edge protection can be used up to a pitch angle of 60° (class C).
We have an extensive network of experienced dealers throughout Europe who will be happy to help you. They can tell you everything about our products and services and provide you with a suitable quote in the language you speak. It is therefore advisable to contact them first. Are you unable to find an answer to your question? Then you can always contact us for additional information.
Yes, absolutely! Contact one of our nearest dealers. Visit the dealer page for more information.
The RSS-Roof products are designed, produced and tested with the greatest care in the Netherlands. If the systems are used according to the instructions and for their intended purpose, a guarantee applies under the following conditions.
Just like scaffolding and climbing equipment, RSS-Roof systems must also be inspected annually. You can have this done by an RSS-Roof dealer or other expert.
Through our rental dealers all our RSS-Roof systems can be easily rented. Contact one of the RSS-Roof dealers.
No, the RSS-Roof systems can only be used in combination with original RSS-Roof systems and components. Other brands and systems may not be used in combination with RSS-Roof. We are not responsible or liable for the use of non-original RSS-Roof systems and/or components.
All our systems are designed and produced in the Netherlands, using only the best quality materials. Your safety is our number 1 priority. This also includes the best quality materials and in-house production.
Perhaps you have a question about our roof edge protection or you are looking for more information. You can find all the information you need on our Frequently Asked Questions page.
