RSS Sloping Roof

Fall protection

RSS Sloping Roof

RSS Sloping Roof is our first and best-selling fall protection system. This sloping roof system can be assembled in no time. Simply hang the stanchions in the gutter and let them rest against the facade. Next, install the fence and wooden board. Once the complete safety system is in place, everyone can ascend safely.

Application possibilities

This system is the ideal solution for all types of pitched roofs with an angle of inclination up to 60°. The RSS Pitched Roof system is easy to install at roof edges and gutters. The system can be assembled and dismantled by one person. For less sturdy gutters (such as plastic gutters, etc.), an optional base plate is available in our range, so that you are always assured of maximum safety. The system is fully certified and tested according to EN 13374 +A1 2019.

Downloads
SELECT YOUR LANGUAGE
Dutch
English
German
French
Italian
Swedish
Czech
Spanish
Danish
Norwegian
Swiss/Austria

Here you will find all documentation

ALWAYS REFER TO THE MANUAL FIRST BEFORE USE

Our manuals are available in many languages. It is essential that before you start to assemble our systems, you always read the manual first and strictly follow the instructions in it. Failure to follow the manual correctly can lead to serious accidents.

Frequently Asked Questions RSS Sloping Roof

Frequently Asked Questions
RSS Sloping roof

How do I know if the gutter is strong enough?

This should always be assessed on site. A zinc box or mast gutter with sufficient gutter brackets (every 60 cm and fixed in healthy wood) is usually a strong gutter. Gutters made of plastic or synthetic material are definitely not. The rule of thumb that you can use: you should be able to stand in the gutter. If the gutter is questionable or bad, the system can still be installed, provided that the RSS base plate is also used. 

Can I also use this system if there is no gutter?

This is only possible when using the RSS base plate.

Can the RSS Sloping Roof System also be used on a flat roof?

Yes, to apply the system to a flat roof, there must be a raised edge of at least 6 cm behind which the upright can hook. In addition, the round plate of the upright must be able to rest against a hard material, such as a wall or facade.

Do I need to wear a harness during setup?

National legislation applies here. Usually you are required to take safety measures from a standing height of 2.5 meters. Think of a harness or other individual safety measures. The system can also be built up with a cherry picker or lift.

What do I do in case of a storm or strong wind?

The system can be used as long as the maximum wind force is observed, see the manual. To make the system more stable, an accessory can be used: the RSS wind protection.

Can I also rent your system?

This can be done at one of our rental dealers. To do this, go to Dealers and navigate to rental.

What can the transport frame be used for?

To store and easily transport the RSS Sloping Roof system. 

What length fences are available?

For RSS Pitched Roof, 3 meter and 2 meter fences are immediately available.

Find a dealer
Near you

Are you looking for quality roof edge protection? Our dealers are located throughout the Netherlands and in various places in Europe.

Contact Us

Write your message or question below