Always check the user manual before, during, and after assembling our RSS Roof systems to ensure you can start your mission safely.
This should always be assessed on site. A zinc box or mast gutter with sufficient gutter brackets (every 60 cm and fixed in healthy wood) is usually a strong gutter. Gutters made of plastic or synthetic material are definitely not. The rule of thumb that you can use: you should be able to stand in the gutter. If the gutter is questionable or bad, the system can still be installed, provided that the RSS base plate is also used.
This is only possible when using the RSS base plate.
Yes, to apply the system to a flat roof, there must be a raised edge of at least 6 cm behind which the upright can hook. In addition, the round plate of the upright must be able to rest against a hard material, such as a wall or facade.
National legislation applies here. Usually you are required to take safety measures from a standing height of 2.5 meters. Think of a harness or other individual safety measures. The system can also be built up with a cherry picker or lift.
The system can be used as long as the maximum wind force is observed, see the manual. To make the system more stable, an accessory can be used: the RSS wind protection.
This can be done at one of our rental dealers. To do this, go to Dealers and navigate to rental.
To store and easily transport the RSS Sloping Roof system.
For RSS Pitched Roof, 3 meter and 2 meter fences are immediately available.
Perhaps you have a question about our roof edge protection or you are looking for more information. You can find all the information you need on our Frequently Asked Questions page.
